Toll Free: 866-440-5133
Banjo Gas Engine Poly Transfer Pumps
Contact to order
Please reference part # M220P11PRO when
you get in touch. Thank you!
More Information
A�3" Banjo Centrifugal Pump coupled to 8 hp B/S Intek Pro OHV enine; 325 US gpm capacity
- SLINGER design separates and protects pump from engine
- Small vanes on backside of impeller funnel pressure away from seal
- Two new Drain and Prime plugs with thumb-screw design. Pump will prime with check valve open.
- Easy-to-Remove impeller for maintenance.
Agwerks recommends coupling your Banjo Pump to an Intek PRO OHV engine from B & S.�
(Compare against Honda GX-series engines.)
- OVERHEAD VALVE design for quieter-running and more efficiency
- On/off switch
- "Oil Guard" oil alert system - prevents re-start without adding oil.
- On/off fuel control switch for enhanced safety during transport
- Super low-tone muffler
- Teflon cylinder sleeve resists wear; extends life
- PTO side-ball bearing reduces friction and extends engine life
- Easy one-pull starting due to float-feed carburetor
- Muffler guard for protection from burns
- Easy-to-access oil-fill pipe - extends to top of engine
- Carrying handle
- Dual Clean air cleaner system - resists dirt/debris to extend life
- available in 5.5, 6.5, or 8.0 hp.
This is a totally redesigned engine from Americas largest small engine maker - completely unlike any other B&S engine you have seen before.� We have sold many of these in the past 3 years and our customers like them for their quiet running and easy starting.